Makita 2705 Instruction Manual page 7

NOTE:
• When using the sub table (back ) during use of
the rip fence, pull out the sub table (back) more
than 50 mm so that it does not hit against the
top end of the rip fence.
► 1. Screw 2. Sub table (L)
Sub table (back) can be installed at the back of the table
to assure wider space. Sub table (L) can be installed on
the left side of the table.
ASSEMBLY
Overview of Table Saw Blade
Guarding System
1
2
4
► 1. Table saw blade guard assembly 2. Antikickback
pawls 3. Riving knife/spreader 4. Riving knife/
spreader release lever location 5. Table saw blade
side guards
WARNING:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
The saw blade and blade guard are not installed on the
tool when it is shipped from the factory.
1
2
1
5
3
Installing or removing saw blade
WARNING:
• Always be sure that the tool is switched off and
unplugged before installing or removing the
blade.
• Use only the Makita socket wrench provided to
install or remove the blade. Failure to do so may
result in overtightening or insufficient tightening
of the hex bolt. This could cause an injury.
3
► 1. Wrench 2. Hex nut 3. Offset wrench
Remove the table insert on the table. Hold the outer
flange with the offset wrench and loosen the hex nut
counterclockwise with the wrench. Then remove the
outer flange.
Assemble the inner flange, blade, outer flange and hex
nut onto the arbor, making sure that the teeth of the
blade are pointing down at the front of the table. Always
install the hex nut with its recessed side facing the outer
flange.
1
► 1. Inner flange 2. Outer flange 3. Saw blade 4. Hex
nut
CAUTION:
• Keep the flange surface clean of dirt or other
adhering matter; it could cause blade slippage.
Be sure that the blade is installed so that
the teeth are aligned in the cutting (turning)
direction.
To secure the blade in place, hold the outer flange with
the offset wrench, then tighten the hex nut clockwise
with the wrench. BE SURE TO TIGHTEN THE HEX
NUT SECURELY.
7 ENGLISH
1
2
2 4
3