Installation - Makita 2705 Instruction Manual

16. Use a push stick when required. Push sticks
MUST be used for ripping narrow workpieces
to keep your hands and fingers well away from
the blade.
17. Pay particular attention to instructions for
reducing risk of KICKBACK. KICKBACK is
a sudden reaction to a pinched, bound or
misaligned saw blade. KICKBACK causes
the ejection of the workpiece from the tool
back towards the operator. KICKBACKS CAN
LEAD TO SERIOUS PERSONAL INJURY. Avoid
KICKBACKS by keeping the blade sharp, by
keeping the rip fence parallel to the blade, by
keeping the riving knife/spreader, antikickback
pawls and blade guard in place for every oper-
ation for which it can be used and operating
properly, by not releasing the workpiece until
you have pushed it all the way past the blade,
and by not ripping a workpiece that is twisted
or warped or does not have a straight edge to
guide along the fence.
18. Do not perform any operation freehand.
Freehand means using your hands to support
or guide the workpiece, in lieu of a rip fence or
miter gauge.
19. NEVER reach around or over saw blade.
NEVER reach for a workpiece until the saw
blade has completely stopped.
20. Avoid abrupt, fast feeding. Feed as slowly as
possible when cutting hard workpieces. Do not
bend or twist workpiece while feeding. If you
stall or jam the blade in the workpiece, turn
the tool off immediately. Unplug the tool. Then
clear the jam.
21. NEVER remove cut-off pieces near the blade
or touch the blade guard while the blade is
running.
22. Knock out any loose knots from workpiece
BEFORE beginning to cut.
23. Do not abuse cord. Never yank cord to discon-
nect it from the receptacle. Keep cord away
from heat, oil, water and sharp edges.
24. Some material contains chemicals which may
be toxic. Take caution to prevent dust inhala-
tion and skin contact. Follow material supplier
safety data.
25. The side guards can be lifted during workpiece
setup and for ease of cleaning. Always make
sure that the side guards are down and resting
flat against sawtable before plugging in the
tool.
SAVE THESE INSTRUCTIONS.
WARNING:
WARNING: MISUSE or failure to follow
the safety rules stated in this instruction
manual may cause serious personal injury.

INSTALLATION

Positioning table saw
525 mm
► 1. Hole diameter 8 mm (5/16")
1
25 mm
(1")
2
► 1. 6 mm (1/4") Std. washer 2. No.10 wood screw 40
mm (1-1/2") min. length
1
► 1. 6 mm (1/4") Std. washer 2. 6 mm (1/4") Mounting
bolt & Nut tighten securely
Locate the table saw in a well lit and level area where you can
maintain good footing and balance. It should be installed in an
area that leaves enough room to easily handle the size of your
workpieces. The table saw should be secured with four screws
or bolts to the work bench or table saw stand using the holes
provided in the bottom of the table saw. When securing the
table saw on the work bench, make sure that there is an open-
ing in the top of the work bench the same size as the opening in
the bottom of the table saw so the sawdust can drop through.
4 ENGLISH
620 mm
(24-9/16")
1
(20-5/8")
2