Advertisement
XFL5 HARDWARE MIGRATION ADAPTER
REMOVING XFL5xx I/O MODULES FROM XSL513/XSL514
TERMINAL BLOCKS
1. Disconnect the power from the XSL513/XSL514 ter-
minal blocks.
2. Unlock the safety latch(es) by moving the slider to the
right on the terminal blocks as shown in the following
figure.
on terminal blocks
3. Make a note of the XFL5xx I/O module type and the
location.
4. Remove the electronics module from the terminal
block (or manual terminal disconnect module) by
pushing a screwdriver between the electronics mod-
ule and the spring clip on the terminal block (or man-
ual terminal disconnect module).
5. Unlock the spring clip by lightly bending upwards
with the screwdriver.
6. Open the plastic cover on the XFL5xx I/O module and
make a note of the module address which is set on
the rotary switch if applicable.
7. Remove all safety latches present at the top of the
terminal blocks in the following sequence:
a. Rotate the safety latch in anti-clockwise direction
as shown in step 'a' and 'b'.
b.
MU1B-0074 IE10 R0518
on XSL512
Safety latch
2
c. Remove the safety latch.
INSTALLATION
WARNING
Electrical Shock Hazard.
Can cause severe injury, death or
property damage.
Disconnect the power supply before beginning
installation to prevent electrical shock and
equipment damage. More than one power supply
may have to be disconnected.
When Installing This Product...
1. Read these instructions carefully. Failure to follow
them could damage the product or cause a hazard-
ous condition.
2. Check the ratings given in the instructions and
marked on the product to make sure the product is
suitable for your application.
3. Installer must be a trained, experienced service
technician.
4. After installation is complete, check out the product
operation as provided in these instructions.
5. Be sure wiring complies with all applicable codes,
ordinances and regulations.
Advertisement
