Connecting To A Computer - Yamaha DPX-830 Owner's Manual

◆ Connecting to a computer

Important
• Make sure that the power of the projector and that of the computer are turned off.
• When connecting the projector to a desktop computer, disconnect the RGB cable that is connected to the monitor.
• This projector may not display any image or not operate correctly depending on the computer you wish to connect. In such
cases, refer to the instruction manual of the connected computer.
To D-SUB terminal
1
COMPONENT
Y PB/CB PR/CR
HDMI D-SUB
S-VIDEO
SERIAL
USB
TRIGGER
VIDEO
To HDMI terminal
1
COMPONENT
Y PB/CB PR/CR
HDMI
D-SUB
S-VIDEO
SERIAL
USB
TRIGGER
VIDEO
14
To monitor port
2
RGB cable
To DVI
terminal
2
DVI-HDMI
conversion cable
(commercially
available)
For analog connections:
1. Connect one end of the supplied RGB cable to the D-SUB
terminal of this projector.
2. Connect the other end of the RGB cable to the monitor port
of the computer.
• Additional devices, such as a conversion connector and an
analog RGB output adapter, are required depending on the type
of the computer to be connected.
• This projector does not support 3-line signals (SYNC-ON-
GREEN signals).
For digital connections:
1. Connect one end of a commercially available DVI-HDMI
conversion cable to the HDMI terminal of this projector.
2. Connect the other end of the DVI-HDMI conversion cable to
the DVI terminal of the computer.
• Additional devices, such as a conversion connector and an
analog RGB output adapter, are required depending on the type
of the computer to be connected.
• When viewing images being input from a digital-connected
computer, press the HDMI button on the remote control.
• Turn on the power of the projector before that of the computer.
• Using a long cable may decrease the quality of projected
images.
• The signal input from the HDMI terminal does not output
through the D-SUB terminal.