Yamaha DPX-1000 Owner's Manual page 26

Digital cinema projector
Hide thumbs Also See for DPX-1000:
Table of Contents

Advertisement

I 4 <SETUP>
S
LOCATION
There are four ways of installing this unit; tabletop or ceiling mounting for front or rear projection. The
DPX-1000 will invert or rotate the projection according to this setting.
KEYSTONE
If the projection unit is at a horizontal or perpendicular angle to the screen the projection image will be
distorted to a trapezoid shape. Use the KEYSTONE setting to electronically correct without increasing
the length of the image. Increase the value when the top of the image is overly wide, and reduce the
value when the lower part of the image is too wide.
When the upper part of the image is wider than the lower
Increase the value in the positive (+) direction
REMOTE CONTROL SENSOR
Use this parameter for switching between the 2 sensors located on the front and rear of the main unit that
receive signals from the remote control. You can operate the main unit with a wired remote regardless of
how this parameter is set.
REMOTE CONTROL ID
S
The main unit can receive commands from the remote control if you set the same ID in the main unit as
is set by the code change switch on the side of the remote control. Use this code change switch to allow
one remote to control two main units independently.
LENS ADJUSTMENT LOCK
Locks the lens so that the V. POS, ZOOM, and FOCUS settings cannot be changed accidentally. Set to
OFF to cancel this function.
WHITE BOOST
Enhances the luster of the white part in the projected image.
ECONOMY MODE
Lowers power supply to the lamp by approximately 20% to prolong its life.
S
MENU COLOR
Selects the color of the characters and background for the on-screen menu display. Press the + or
button to access the submenu and change color selections.
MESSAGE
Set whether to display messages of any type on screen.
S
TRIGGER OUT
Set the external control TRIGGER OUT terminal 12V signal emission to "LAMP" to synchronize it to
the ON/OFF state of the lamp, to "FAN" to synchronize it to the fan, and to "RS-232C", to receive ON/
OFF signals through the RS-232C terminal.
S
BAUD RATE
Sets the transmission speed of the RS-232C terminal.
This setting becomes valid from the next time you switch the unit on.
Menu item
S
FRONT/TABLE, FRONT/CEILING, REAR/
TABLE, REAR/CEILING
–100 to 0 to +100
When the lower part of the image is wider than the top
Decrease the value in a negative (–) direction
FRONT&REAR/FRONT/REAR/OFF
ID 1/ID 2
OFF/ON
OFF/ON
OFF/ON
MONOTONE/COLOR
OFF/ON
LAMP/FAN/RS-232C
9600bps/19200bps/38400bps/57600bps/
115200bps
Menu structure
Selections
21
E-

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dpx 1000 - dlp projector - hd 720p

Table of Contents