Yamaha MIXING CONSOLE Owner's Manual page 206

206
Chapter 17—Remote Control
2 Press the DISPLAY ACCESS [DIO/SETUP] button repeatedly until the
DIO/Setup | Remote page appears, then set the TARGET parameter to USER
DEFINED.
You can now use the MIDI Remote function. Refer to the previous section for more infor-
mation on using the MIDI Remote function.
3 Move the cursor to the desired bank button (BANK parameter buttons 1–4),
then press [ENTER].
4 Press the [SEL] buttons for the desired channels.
Currently-assigned MIDI messages appear in the ON and FADER sections.
Tip: You can also choose the desired channels using the ID, SHORT, and LONG parameters.
5 Move the cursor to the LEARN button in the ON section, then press [ENTER].
MIDI messages received at the MIDI IN port of the 01V96 will be assigned to the DATA
parameter boxes in the ON section.
6 Press and hold down the MIDI keyboard foot switch.
The MIDI Hold On message is assigned in the DATA parameter box.
MIDI messages are described below:
• 00–7F ............................. MIDI messages are expressed in hexadecimal.
• END ............................... This message indicates the end of MIDI messages. Subsequent
• –...................................... This message indicates that no messages are assigned to the
Tip: When you click the LEARN button to assign MIDI messages, the 01V96 automatically
recognizes the end of the messages and assigns END and "–."
7 While continuing to hold down the foot switch, turn off the LEARN button.
8 Move the cursor to the third parameter box ("7F" in this example), then
rotate the Parameter wheel to change the value to SW.
"SW" is a variable that changes depending on the [ON] button's on/off status. You can use
the following variables in MIDI messages.
• SW.................................. This variable is selectable only in the DATA parameter boxes of
• FAD................................ This variable is selectable only in the DATA parameter boxes of
01V96—Owner's Manual
messages assigned in the DATA parameter boxes will be
ignored.
DATA parameter boxes.
the ON section. When the [ON] buttons are turned on, "7F"
(127 in decimal) is output. When the [ON] buttons are turned
off, "00" (0 in decimal) is output.
the FADER section. When you operate the faders, continuously