Deleting Parts - Yamaha D24 Owner's Manual

102
Chapter 10—Editing Parts

Deleting Parts

The Part Delete function is used to delete part of a track. Subsequent material on the
track is moved forward.
The following points, which can be adjusted in sub-frame steps, can be selected when
specifying edit points: LAST REC IN, LAST REC OUT, A, B, or a locate memory from
1 through 99. Note that you must set these points before entering the Part Delete func-
tion. See the Quick Locate Chapter on page 57 for more information about setting
these points.
Press the [EDIT] button.
1
The EDIT indicator lights up.
Use the JOG/DATA dial to select "PART EDIT," and then press the [ENTER] but-
2
ton.
Use the JOG/DATA dial to select "DELETE," and then press the [ENTER] button.
3
"PART DELETE—TR nn" appears on the display ("nn" being the number of the track
from which the part is to be deleted).
Use the JOG/DATA dial to select the track.
4
You can select individual tracks, track pairs, or all tracks: 1–8, 1/2–7/8, or ALL. To delete
part of a virtual track, assign it to a main track first, and then delete.
Press the [ENTER] button.
5
"DEL TR nn—ST MARK IN" appears on the display ("nn" being the number of the
selected track and "ST" being the start point of the part to be deleted).
Use the JOG/DATA dial to select one of the following points: MARK IN, MARK
6
OUT, MARK A, MARK B, or a locate memory from 1 through 99.
Press the [ENTER] button.
7
"DEL TR nn—ST 00:00:00.00.0" appears on the display ("00:00:00.00.0" being the
position of the selected point).
Use the JOG/DATA dial or keypad to adjust the start position, and then press
8
the [ENTER] button.
"DEL TR nn—ED MARK IN" appears on the display ("ED" being the end point of the
part to be deleted).
Use the JOG/DATA dial to select one of the following points: MARK IN, MARK
9
OUT, MARK A, MARK B, or a locate memory from 1 through 99.
Press the [ENTER] button.
10
If the duration of the specified part is less than 15 milliseconds, the minimum size, the
message "TOO SHORT" appears.
"DEL TR nn—ED 00:00:00.00.0" appears on the display ("00:00:00.00.0" being the
position of the selected point).
Use the JOG/DATA dial or keypad to adjust the end position, and then press
11
the [ENTER] button.
"EDIT DELETE—ARE YOU SURE" appears on the display.
D24—Owner's Manual