Cooling Fins; Fuel Filter And Fuel Tank; Spark Arrester - Honda Loke-26 4T Instruction Manual

6.10
COOLING FINS (FIG. 12)
I
NSPECTION
1. Loosen the 5mm hex bolt, then remove the top cover.
2. Disconnect the spark plug cap.
3. Inspect the engine cooling fins and clean out debris if
necessary.
4. Reconnect the spark plug cap.
5. Install the top cover and tighten the 5mm hex bolt securely.
6.11
FUEL FILTER AND FUEL TANK (FIG. 13-14)
Fuel filter inspection and fuel tank cleaning.
1. Check that the engine oil filler cap is tightened securely.
2. Remove the fuel filler cap and drain the fuel into an approved petrol container by tipping the engine
toward the fuel filler neck.
3. Pull the fuel filter out through the fuel filler neck by hooking the black fuel tube with a piece of wire, such
as a partly straightened paper clip.
4. Inspect the fuel filter. If the fuel filter is dirty, wash it
gently with non-flammable or high flash point solvent. If
the fuel filter is excessively dry, replace it.
5. Remove water and dirt from the fuel tank by rinsing the
inside of the fuel tank with non-flammable or high flash
point solvent.
6. Insert the fuel filter into the fuel tank and tighten the fuel
filler cap securely.
6.12

SPARK ARRESTER

In some areas it is illegal to operate an engine without a
spark arrester. Check local laws and regulations. The spark
arrester must be serviced every 100 hours to keep it
functioning as designed.
If the engine has been running, the muffler will be hot.
Allow it to cool before servicing the spark arrester.
S
PARK ARRESTER REMOVAL
1. Loosen the 5mm hex bolt, then remove the top
cover.
2. Remove the 4mm screws from the spark arrester
and remove the spark arrester from the muffler
S
PARK ARRESTER REMOVAL
1. Loosen the 5mm hex bolt, then remove the top cover.
2. Remove the 4x6mm self-tapping screws from the spark arrester and remove the spark arrester and
exhaust filter from the muffler
L -26 4 (FIG. 15-16)
OKE T
B -36 4T (FIG. 17-18)
ALDER
17