(3) Make configuration and parameter data
Double click on the selected device.
And make the configuration data and parameter data.
In the configuration data is set the byte offset address from start address of output link area or input link area.
For the details of the configuration data and the parameter data to the slave equipment, please refer to the
manual of each slave equipment.
Fig. 3.4 and Fig. 3.5 is the example for EH-IOCP.
Fig. 3.4 Configuration data for EH-IOCP
Fig. 3.5 Parameter data for EH-IOCP
Chapter 3 CONFIGURATIONS
3-5