Honeywell HON 512 User And Maintenance Manual page 79

Maintaining the outlet
body
HON 512 with HON 650 pilot user manual
If ...
The magnetic ring is resting over the guide pin in
the position shown in step 4
The magnetic ring is NOT resting over the guide
pin in the position shown in step 4, but is instead
in a higher or lower position
Figure
Proceed as follows:
Figure
then ...
proceed with step 6.
proceed with step 5.
Step Description
5 Remove the magnetic ring from the guide
pin, turn it 180°, and place it back over the
guide pin.
6 Place the sight glass (2) and the cover ring
(1) back on the guide pin. Make sure that
the magnetic ring stays in the required
position.
7 Install the retaining ring (1).
Step Description
1 Unscrew the screws (1) that connect the
two release plates (2, 3) to the outlet body.
Maintenance
79