Advertisement
1
Bind Zone-1 Thermostat to Zone-1 Zone Valve Controller (BDR91)
1
Install and power BDR91
Zone Valve Controller (see
BDR91 instructions).
Press
10sec
4
Put Thermostat into BIND
mode by pressing below
and left of display for 10
seconds (until a flashing
'bo' is displayed).
5
7
Thermostat will display binding confirmation
+ signal strength (5 = good signal) for a few
seconds before returning to normal operation.
Thermostat to Zone-2 Zone Valve Controller
2
Connect Remote Access Gateway to power
Continue to step
2
Press and hold the button
for 15 seconds (until the red
LED blinks rapidly) to clear
any stored binding data.
Press
Once
5
Send BIND signal by
pressing the BIND
button again.
few
secs
21
.5
Repeat this process for binding Zone-2
Press
15sec
3
6
on the next page...
3
Press
5sec
Put BDR91 into BIND mode
by pressing the button
again for 5 seconds (until
the red LED blinks slowly).
The red LED on the BDR91
will stop blinking and go off.
LED Status
Advertisement
