Table of Contents
Advertisement
Controls &
Components
To reduce your risk of
serious injury, read this
entire
using machine.
Refer to the following figure and descriptions to
become familiar with the basic controls and com-
ponents of this machine. Understanding these
items and how they work will help you understand
the rest of the manual and minimize your risk of
injury when operating this machine.
A
B
C
L
K
J
Figure 1. Basic control locations.
A. Hold-Down Clamp Lock Handle: Allows
user to adjust and lock height of hold-down
clamp assembly on hold-down post.
B. Hold-Down Clamp Assembly: Secures
workpiece to table. Two mounting holes allow
the clamp to accommodate different-sized
workpieces.
-4-
manual
BEFORE
D
E
F
G
I
H
C. Hold-Down Clamp Lock Lever: Holds and
releases pressure against workpiece.
D. Table Feed Handle: Moves the table in and
out and side to side during boring operations.
E. Indexing Guide: Has four pre-spaced index-
ing sizes (
⁄
",
⁄
",
5
3
8
4
repeat line-boring operations up to 7
when used with indexing guide lock pin (G).
F.
Indexing Guide Lock Handle: Locks index-
ing guide (E) in position.
G. Indexing Guide Lock Pin: Features a
spring-loaded head to drop into holes on the
indexing guide collar (E) to control side-to-
side table travel. Pull the pin out and rotate
the knob 90° for free table movement side to
side and front to back.
H. Chuck Direction Switch: Features an L
(left), N (neutral), and R (right/clockwise)
rotation setting depending upon operation
and bit type.
IMPORTANT: Always turn switch to 0 (neu-
tral) and allow chuck to stop spinning before
changing chuck direction. Bit rotates coun-
terclockwise on L (left) and clockwise on R
(right) as user faces chuck.
I.
ON/OFF Switch: Starts and stops motor.
Remove switch disabling key to prevent motor
from starting when machine is unattended.
J.
Table Height Lock Lever: Secures table at
selected elevation.
K. Table Height Handwheel: Moves the table
up and down.
L. Fence Angle Gauge: Allows fence adjust-
ment of up to 60º left/right, and adjusts
inward/outward depending upon workpiece
size. The fence and angle gauge are remov-
able for oversized workpieces.
Model G0846 (Mfd. Since 02/18)
⁄
", and 1" on-center) for
7
8
⁄
" wide
1
2
Advertisement
Table of Contents
