RIDGID R4091 Operator's Manual page 13

ASSEMBLY
ASSEMBLING THE WSUV™ WET SAW
UTILITY VEHICLE / LEG STAND
See Figure 7.
Many of the WSUV™ / leg stand parts are movable. All
hardware must be tightened securely but not so tight that
the utility vehicle / leg stand won't open and close. For easier
assembly, match letter to letter.
 Place a curved spacer over the end of the lower brace.
 Insert a hex head bolt and small flat washer at the bottom
of the right outer tube and into the lower brace. Tighten
securely. Repeat for the other side.
 Place a carriage bolt through the center hole in the outer
tubes then place a spacer on the bolt.
 Slide the bolt/spacer into the inner leg assembly and se-
cure in place using a lock nut. Do not overtighten. Repeat
for the other side.
LEFT
UPPER TUBE
LEFT
OUTER TUBE
HEX HEAD
BOLT
RIGHT
OUTER TUBE
SPACER
LOCK NUT
CARRIAGE
BOLT
LOWER
BRACE
 Place the center brace on top of the inner leg assembly
(curve side up) with the stop pin under the pedal assembly
latch.
NOTE: The stop pins rest on top of inner leg assembly.
 Insert a carriage bolt through the top hole of the inner leg
assembly then slide a spacer on the bolt. Repeat for the
other side.
 Slide the center brace onto the bolt and secure in place
using a lock nut. Repeat for the other side.
 With the curve handle turned downward, secure the up-
per tubes to the leg stand using carriage bolts, spacers,
and lock nuts.
 Locate the lock nut and two flat washers.
 Slide the large flat washer, wheel, and medium flat washer
onto the axle through the hole in the center of the wheel.
Secure in place using lock nut.
 Repeat with the second wheel.
STOP PIN
WHEEL
FLAT WASHER,
MEDIUM
LOCK NUT
13 — English
RIGHT
UPPER TUBE
CENTER
BRACE
INNER LEG
ASSEMBLY
AXLE
FLAT
WASHER, LARGE
Fig. 7