Functions Of Elements In Operator Access Areas; Table 2-1 Function Of Elements In Operator Access Areas - Hitachi HF-W2000 35 User Manual

2. CONSTRUCTION
2.3

Functions of Elements in Operator Access Areas

See Table 2-1.

Table 2-1 Function of Elements in Operator Access Areas

Name
Power switch
Status lamp (STATUS)
Alarm lamp (ALARM)
Drive Access/Standby lamp
(DRIVE/STBY)
HDD1 status lamp and HDD2 status
lamp on D Model (HDD1 status
lamp for drive bay 1 and HDD2
status lamp for drive bay 2)
Reset switch (RESET)
AC inlet
Power supply unit
Audio port (LINE IN)
Audio port (LINE OUT)
Serial port (COM1) (9 pins:
RS-232C-A)
RAS external contact interface (25
pins: EXT) (option)
Video port (analog RGB)
Video port (DVI-D)
PCI slot
PCI-E slot
Keep pressing this switch for 4 seconds or more to turn off the primary
power and place the Equipment into the standby status (for emergency).
Lamp indicator Status
On (green) The Equipment is operating (RUN state).
On (red) The Equipment is not operating (STOP state).
 during start-up of the Equipment
 in a error stop during shutdown
 in a deadlock of the Equipment caused by an error
 when RAS software is not installed
Off The Equipment is in the main-power-off state or in the
standby state.
Turned on (red) when the following abnormality is detected:
 Stop of fan in the Equipment
 Temperature abnormality in the Equipment
 Failure in one of the mirrored disks (on D model)
Lamp indicator Status
On (green) HDD or DVD is being accessed.
On (orange) The Equipment is in the standby status (when only
auxiliary power is on).
Off Power supply is disconnected or the Equipment is
operating.
Lamp indicator Status
Off Subject HDD is online (no error).
On (red) Subject HDD is offline (HDD power down).
Blinking (red) Rebuilding (copy) is in progress. Only the indicator for
in one side the destination HDD blinks.
 No HDD is installed in drive bay 1 or drive bay 2.
Blinking (red)
 Combination of HDD and RAID board is in error.
in both sides
Press this switch to restart the Equipment (hardware reset). Also press this
switch during the OS startup to collect memory dump. Pressing after
completion of memory dump collection causes hardware reset.
Connects the AC power cord.
Accepts the AC input voltage ranging from 100 to 240 V.
Audio line input.
Audio line output.
Connects a device that uses the serial interface (modem etc). (See
Subsection 4.8.1, "Connector specifications".)
Provides an external control interface. (See Subsection 4.8.1, "Connector
specifications".)
Connects the analog display interface cable. (See Subsection 4.8.1,
"Connector specifications".)
Connects the digital display interface cable. (See Subsection 4.8.1,
"Connector specifications".)
PCI board is inserted into this slot.
PCI-Express board is inserted into this slot.
2-6
Description
(Continued on next page)