Parameter settings
Contents of this chapter
This chapter contains the parameter settings related to the safety function.
Drive parameter settings
The parameter settings in ACS880 primary control program:
No.
Name
14.01
Module 1 type
14.02
Module 1 loca-
tion
14.09
DIO 1 function
14.14
DIO 2 function
14.34
RO1 source
21.04
Emergency
stop mode
21.05
Emergency
stop source
Default value
Description
FIO-01
Activates (and specifies the type of) I/O extension module
1.
Slot 1
Specifies the slot (1...3) on the control unit of the drive into
which the I/O extension module is installed.
Input
Selects whether DIO1 of the extension module is used as a
digital input or output.
Input
Selects whether DIO2 of the extension module is used as a
digital input or output.
P.14.5.1-
Selects a drive signal to be connected to relay output RO1.
In this case, the RO1 is energized by the status of DIO2 of
the FIO module (inverted value).
Eme ramp stop
Selects the way the motor is stopped when an emergency
(Off3)
stop command is received.
P.14.5.1
Selects the source of the emergency stop signal. In this
case, the source is DIO2 of the FIO module.
Parameter settings 29
5