Table of Contents
Advertisement
Installation position (continued)
Note
z This illustration assumes that the projector will be installed so that the projected image fills the screen and
properly aligned with it.
z This drawing is not in exact scale.
Height of the projection
SH
area
Width of the projection
SW
area
Diagonal length of the
SD
projection area
L(LW/LT)*
Projection distance
1
*1: LW : Minimum distance; LT : Maximum distance
Note
z Depending on the product, the appearance may differ from the illustrations in these installation instructions.
Attention
z Install the projector at least 500 mm (19-11/16") on the air intake ports (1,000 mm (39-3/8") on the exhaust port
side) away from the surrounding walls or objects in order to ensure that the air intake/exhaust ports of the pro-
jector will not be blocked.
z Avoid setting up in places which are subject to sudden temperature changes, such as near an air conditioner or
lighting equipment (studio lamps, etc.).
■ Dimensional relationship
For the formula of the projection distance (L) and the other specifications (H, H1 / H2, L1F/L2F, L1R / L2R, W1 /
W2), refer to the appendix at the end of this instruction.
6 - ENGLISH
H
Distance from the center of lens to the image upper end
Distance from the center of lens to the attachment plate (including
H1 / H2
plate thickness)
L1F / L2F
Distance from the center of attachment plate to the front end of lens
Distance from the center of attachment plate to the rear end of
L1R / L2R
projector
W1 / W2
Distance from the center of attachment plate to the center of lens
Advertisement
Table of Contents
