Installation Instructions; Instructions - Whirlpool MC8131XE Use And Care Manual

Microwave-convection oven
Hide thumbs Also See for MC8131XE:
Table of Contents

Advertisement

Installation
Instructions
Before you begin operating the oven, carefully read the following instructions.
1. Empty the microwave oven and clean
inside it with a soft, damp cloth. Check for
damage such as misaligned door, damage
around the door, or dents inside the oven
or on the exterior. If there is any damage,
do not operate the unit until it has been
checked by an authorized Whirlpool
service technician and any repairs made.
2. Put the oven on a cart, counter, table, or
shelf that is strong enough to hold the
oven and the food and utensils you put in
it. (The control
side of the unit is the
heavy side. Use care when handling.)
The weight of the oven is approximately
58 Ibs. The microwave oven should be
at a temperature above 50°F (10%) for
proper operation.
Exhaust
vents
Power
supply
cord -
Exhaust
vents--l
Air Intake openlngs
(on bottom)
NOTES:
l
Do not block the exhaust vents or rear air
intake openings. Allow a few inches of
space at back of oven where intake
openings are located. Blocking the air
intake openings and exhaust vents could
cause damage to the oven and poor
cooking results. Make sure the microwave
oven legs are in place to ensure proper
airflow.
l
Do not install the oven next to or over a
heat source (for example, a cooktop or
range) without a UL approved trim kit or
without being in a UL approved built-in
configuration.
Also, do not install oven in
any area where excessive heat and steam
are generated. This could cause a fire,
electrical shock, excessive exposure to
microwave energy, other personal injury,
or damage to the outside of the cabinet.
Fire Hazard
Do not install the oven next to or
over a heat source.
Doing so can result in death, fire,
or electrical
shock.
Built-in
kits
You can build your microwave-convection
oven into a wall or cabinet by using one of
the trim kits listed on page 17.
These kits are available from your
Whirlpool Dealer. if your dealer does not
stock the kit you can order it, by kit part
number, by calling l-800-253-1301
and
following the instructions
and telephone
prompts you hear.
continued
on next page
9

Advertisement

Table of Contents
loading

Table of Contents