Component Names And Functions; Figure 2-3 Fl.net Module Component Names; Table 2-9 Fl.net Module Component Names And Functions - Hitachi S10mini User Manual

2.2.2 Component names and functions

1
LQE500
2
3
10BASE
10BASE
GND

Table 2-9 FL.NET Module Component Names and Functions

No. Name
1 TX LED (Green)
2
RX LED (Green)
3
LER LED (Red)
4
Module number selector
switch
5 10BASE5 interface
connector
6 10BASE-T interface
connector
7 Power input terminals
8 Frame ground
4
FL.NET
TX
MODU.
RX
No.
LER
5
-5
6
-T
7
12V
FG
8

Figure 2-3 FL.NET Module Component Names

This LED indicates while data is being transferred.
This LED indicates while data flows along a transmission path (a carrier is
detected).
This LED indicates when a fatal fault occurs, unconnected FA link, or FA
link communication failure. When the module is installed in a different
model from the model in which the parameters shown in "5 USER
GUIDE" were set, a ROM 3 checksum error occurs and this LED comes on.
This switch performs main module/submodule setup or selects a
communication port type.
Connect this connector to the S10mini and S10V or other controller.
Connect this connector to the S10mini and S10V or other controller.
Connect these terminals to the power supply (12 VDC) for the transceiver
that is to be connected to the 10BASE5 interface connector.
Connect this ground to the shielded wire in the transceiver cable.
1
LQE502 FL.NET
2 TX
RX
LER
3
10BASE
-5
10BASE
-T
12V
GND
FG
Function
2-9
2 FL.NET MODULE
4
MODU.
No.
5
6
7
8