Physical Side Error Recovery (From 5400H); Read/Write Control (From 5800H) - HP LTO Ultrium Technical Reference Manual

Error
50A4h
50A5h
50A6h
50A7h
50A8h
50A9h
50AA
50ABh
50ACh

Physical side error recovery (from 5400h)

Error
5400h
5401h

Read/write control (from 5800h)

Error
5800h
5801h
5802h
5803h
5804h
5805h
5806h
5807h
5808h
5809h
Description
The value of TapeWritePassValue CurrentWrap and SDL sheet has been set.
Shows the value that the Max ATS has been set.
An error code of 7501h (Loss of LPOS) has been detected, causing a reduction in the servo
MR bias.
A RampToSpeedRsp signal has arrived while trying to abort.
Excessive offtracks have been seen on a Fuji tape.
The drive tried to perform an ERT whilst the tape was not threaded.
The firmware may have followed a path in which the formatter was not aborted before a re-
write.
The firmware has managed to write a dataset that finishes past EOW.
An LTO 5 dataset was encountered whose Encryption Algorithm ID was not 02h.
Description
Not an error—just requests a trace log bank switch.
Shows the LPOS and MM position for the start of tuning.
Description
Success.
Null point.
Invalid parameter.
No hardware.
SPI transfer error.
Prometheus set error.
Hyperion set error.
Daughter set error.
Calibration did not complete.
Servo bias status false.
Volume 1: hardware integration 113