Operation - Makita DHP484 Instruction Manual

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
drill bit
Optional accessory
Fig.10: 1. Sleeve 2. Close 3. Open
counterclockwise.
Installing hook
Fig.11: 1. Groove 2. Hook 3. Screw
the hook, insert it into a groove in the tool housing on
loosen the screw and then take it out.
Installing driver bit holder
Optional accessory
Fig.12: 1.

OPERATION

CAUTION:
Always insert the battery cartridge
all the way until it locks in place.
you.
CAUTION:
When the speed comes down
extremely, reduce the load or stop the tool to
avoid the tool damage.
control the twisting action.
Fig.13
First, turn the action mode changing ring so that the
apply pressure to the tool. Start the tool slowly and then
increase the speed gradually. Release the switch trigger
as soon as the clutch cuts in.
First, turn the action mode changing ring so that the
2.
this operation.
clogged with chips or particles. Instead, run the tool at
Optional accessory
First, turn the action mode changing ring so that the
arrow points to the
Drilling in wood
the workpiece.
8 ENGLISH
Screwdriving operation
CAUTION:
Adjust the adjusting ring to the
proper torque level for your work.
CAUTION:
Make sure that the driver bit is
inserted straight in the screw head, or the screw
NOTE: When driving wood screw, pre-drill a pilot hole
Hammer drilling operation
CAUTION:
There is a tremendous and sud-
at the time of hole breakthrough, when the hole
becomes clogged with chips and particles, or
when striking reinforcing rods embedded in the
concrete.
Blow-out bulb
Fig.14: 1.
Drilling operation
marking.