Lifting Machine; A.) Inspection And Cleaning Of Machine; B.) Foundation, Installation, And Leveling - Sharp 1118H Operations Manual & Parts List

Table of Contents

Figure 1 – Lifting machine

Lifting machine, arrange rope or cable as shown in figure 1, and check to see if the

correct balance has been obtained. Then insert pads of soft cloth between the edges of the

rope and machine. The net weight of this machine is approx 1050kgs (2300 lbs). So the

rope or cable must be rated at 3000 lbs capacity.

An inspection should be made after arrival of the machine in your plant. Look for possible

damage caused by shock or vibration during transportation, also check for any missing

parts, standard tools or other equipment.

In shipment, all exposed surfaces of the machine are coated with a antirust liquid. Before

moving carriage and cross-slide, leadscrew tailstock...etc, these surfaces should be

thoroughly cleaned to remove all antirust liquid use a soft brush and solvent. This is very

important because it can prevent any dirt or grit which may have accumulated on the

antirust liquid from working under the sliding members and causing undue wear.

※CAUTION：：：： DO NOT USE COMPRESSED AIR TO CLEAN, WHICH WILL

REDUCE THE MACHINES LIFE.

A fairly flat foundation and proper installation will provide the machine long-term high

accuracy, so supplying a good solid foundation of proper thickness is important. (Generally ,

a thickness of 300mm (12") is considered to be enough.) The machine has six adjustable

feet on the coners of the pedestal base, used for leveling the machine. Place the pads

under the feet of pedestal. To adjust, loosen the set screw and raise or lower the foot with a

pin wrench so that all six feet rest firmly on the floor. When the adjustment is done, tighten

set screws.

Table of Contents

Show Quick Links

Table of Contents