Grizzly G0555 Manual

Disconnect power to the
machine when perform-
ing any maintenance or
assembly. Failure to do
this may result in serious
personal injury.
Grizzly's Model H3051 Extension Block Kit
(shown in Figure 1) increases the cutting height
of the Model G0555 Bandsaw to 12".
To install the Extension Block Kit:
1. Disconnect the bandsaw from the power
source!
2. Open the wheel covers and remove the
blade per manual instructions.
3. Remove the left-side blade guard (Figure 2).
4. Remove the power switch assembly (Figure
2). DO NOT disconnect the wiring and wait
until Step 12 to remove the guide post
assembly.
5. Have an assistant support the upper arm
assembly (Figure 3), then loosen the nut and
slide the bolt out. Remove the upper arm and
set it aside. Note—The upper arm is pinned
to the base. If removal is difficult, carefully
rock it loose.
6. Place the extension block onto the base pins.
7. Have an assistant place the upper arm onto
the extension block pins and hold it in place
(Figure 4).
8.
Place a washer over the long extension bolt
and slide the bolt down through the exten-
sion block.
Model G0555
Extension Block Kit
Figure 1. Extension Block Kit.
Power
Switch
Figure 2. Power switch and left side blade
Figure 3. Loosening bolt while an assistant sup-
ports the upper arm assembly.
Left-side
Blade
Guard
guard.