Troubleshooting - RIDGID SeeSnake LCD Pak Operator's Manual

Chart 1 Troubleshooting
PROBABLE FAULT
PROBLEM
LOCATION
No power to SeeSnake
connector.
Connections faulty.
Camera video image
not seen.
Monitor set to wrong Source.
Batteries Low.
CountPlus settings incorrect
Count accuracy
for reel or cable being used.
seems unreliable.
Counting from a zero point
(CountPlus)
other than the one intended.
Low Battery warning
CountPlus Battery dead or
appears on screen.
near-dead.
(CountPlus)
Low Battery Buzzer
sounds or Battery LCDPak 18 V batteries low.
LEDS are both red.
The symbol "+"
appears after the on-
Physical cable measurement
screen distance
has exceeded the cable
measurement.
parameter in settings.
(CountPlus)
SOS blinking on
No video signal.
Power Key LCD.
14
SOLUTION
Check power is correctly plugged in.
Check switch on LCDPak monitor.
Check alignment and pins of connection to LCDPak unit from
SeeSnake.
Check orientation, seating, and pin condition in the
SeeSnake connection.
Press the Source key on the LCD monitor until it sets to AV1
video.
Recharge batteries.
Verify the settings are correct for the SeeSnake cable length,
cable diameter and reel type you are using.
Confirm you are measuring from the intended zero-point.
Reset zero-point using Zero Key (Page 12).
Replace 3-volt battery in the CountPlus (CR2450).
Recharge LCDPak batteries. Switch to external power
(110VAC).
Verify the actual length of your installed cable; re-set the reel
and cable settings for the correct reel type and actual cable
length and diameter as described in the CountPlus manual.
Check Source setting of monitor and re-seat SeeSnake
system cable connection.
Ridge Tool Company