Install The Rack Latches - Lenovo ThinkAgile MX Certified Node 2U User Manual

Step 3. On each side of the server, slide the rack latch forward slightly and then remove the rack latch from
the chassis.
Figure 47. Rack latch removal
If you are instructed to return the old rack latches, follow all packaging instructions and use any packaging
materials that are provided.

Install the rack latches

Use this information to install the rack latches.
Chapter 4 "Read
the
installation
Guidelines" on
page 27
Note: If the rack latches are not assembled with a VGA connector or the front I/O assembly, you can install
the rack latches without powering off the server.
To install the rack latches, complete the following steps:
Step 1. Touch the static-protective package that contains the new rack latches to any unpainted surface
on the outside of the server. Then, take the new rack latches out of the package and place them on
a static-protective surface.
"Power off
the server
for this task"
on page
Chapter 5
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 29
.
Hardware replacement procedures
77