Quick Installation Guide; Contents Of This Guide; Obey The Safety Instructions - ABB ACQ580-04 Series Quick Installation Manual

Quick installation guide

Contents of this guide

This guide tells you briefly how to install the drive module into a 600 mm wide cabinet.
For installation examples in different cabinets and more detailed instructions,
engineering guide lines, technical data and complete safety instructions, see the
hardware manual (www.abb.com/drives: Select Document Library and search for
document number 3AXD50000048677 [English]).

Obey the safety instructions

See figure A on page 13. If you ignore these instructions, injury or death, or damage to
the equipment can occur.
WARNING! Handle the drive module carefully. Open the support legs by
pressing each leg a little down and turning it aside (1, 2).
Do not tilt the drive module. It is heavy and its center of gravity is high.
The module will overturn from a sideways tilt of 5 degrees. Do not leave the module
unattended on a sloping floor.
To prevent the drive module from falling, attach its top lifting lugs with chains to the
cabinet frame before you push the module into the cabinet. Work carefully preferably
with help from another person. Keep a constant pressure with one foot on the base of
the module to prevent the module from falling on its back.
WARNING! If you are not a qualified electrician, do not do installation or
maintenance work. Go through these steps before you begin any installation
or maintenance work.
1. Clearly identify the work location.
2. Disconnect all possible voltage sources.
• Open the main disconnecter of the drive.
• Open the disconnecter of the supply transformer as the main disconnecter of
the drive does not remove the voltage from the input busbars of the drive.
• Make sure that reconnection is not possible. Lock the disconnecters to open
position and attach a warning notice to them.
• Disconnect any external power sources from the control circuits before you
do work on the control cables.
• After you disconnect the drive, always wait for 5 minutes to let the
intermediate circuit capacitors discharge before you continue.
3. Protect any other energized parts in the work location against contact.
4. Take special precautions when close to bare conductors.
5. Measure that the installation is de-energized.
• Use a multimeter with an impedance of at least 1 Mohm.
Quick installation guide 5