Advertisement
Quick Links
Advertisement
Related Manuals for Dancover Storage Tent PRO
Summary of Contents for Dancover Storage Tent PRO
- Page 1 Manual Storage Tent PRO 8x12x5,2m PVC 04-10-2019...
-
Page 2: Safety Advice
The tent must be totally dry before you repack and store it to avoid mildew. Note: Dancover warranty applies only to the normal use of the Product, normal wear and tear excepted, in accordance with written use instructions or manual. The warranty does not apply to damage caused by accident, abuse, misuse, or modification of the Product. - Page 3 Instruction 8x12 Back leg Back leg Extension pipe Crossbar Ceiling rail Ceiling rail Corner arch Center arch Connecting pipe Connecting pipe Extension pipe Extension pipe Door pillar Fasten bar Foot base Connecting component Nail 10x350mm Nail 6x180mm Nail 7x300mm 04-10-2019...
- Page 4 Spiral nail 10x700mm Cross bar 1.75" Screw 2.5" Screw 4" Screw Wing nut Floor Bracket (set of 2 pcs) Bungee ball Spanner Bolt with nut Tie-down kit Steel clip Steel wire Rope Rope Roof Endwall 04-10-2019...
- Page 5 Attention Please use gloves when assembling the metal frame of this unit. The metal components of this product have been treated, with a rust preventive coating. This coating is not dangerous, but you may grease your hands during assembly. We recommend that you wipe metal parts clean with a mixture of warm water and dish detergent prior to assembly.
- Page 6 Please assemble the frame in these steps. All sizes have similar assemble step. Step 1 When assembling the tent, make sure that all the wing nuts are attached to the inside. Connect one center arch pipe(8) with the extension pipe(11). Attach the corner arch(7) to the ends of the extension pipe(3).
- Page 7 Step 5, Start setting up one side first. Connect the corner arch 7) with the legs (1 and 2). Secure the frame using the connecting pipes (9 and 10). Attach the diagonal pipes (4) to the back legs (1). Please refer to the completed frame pictures to attach the diagonal pipes.
- Page 8 Step 7, Assemble the pillar set like on the picture below. Step 8, Use the ropes to attach the door and cover to the frame. Find a proper way and strength to attach the cover to the frame carefully. Please do not use too much strength to tear the eyelet out of fabric.
-
Page 9: Contact Information
Contact information Head office: Dancover A/S For more information Nordre Strandvej 119 G please visit: 3150 Hellebæk www.dancovershop.com Denmark National contact Denmark: 70 26 76 20 Spain: 911 436 828 denmark@dancover.com espana@dancover.com UK: 020 8099 7570 Italy: 02 479 21 198 uk@dancover.com...