To Stop The Product; To Switch Off The Product; Timer And Standby - Husqvarna Automower 105 Operator's Manual

charging station to charge the battery. When the
battery is charged, the product moves out of the
charging station and stops. The product is now
prepared to start operation, but needs
confirmation from the operator first.
Note: If you want to cut the main area after the
battery is charged, set the product to
before placing it in the charging station.

4.4 To stop the product

1. Push the STOP button on top of the product.
The product stops and the blade motor stops.

4.5 To switch off the product

1. Press the STOP button on top of the
product.
2. Set the Main switch to position
WARNING: Always switch off the
product using the main switch if it
requires maintenance, or if the product
must be moved outside the work area.

4.6 Timer and Standby

The product has an inbuilt standby period
according to the Standby time table. The standby
period provides for instance a good opportunity to
water or play games on the lawn. The standby
time is depending on how much active time
(cutting and searching) the product has each day.
The active time is in turn depending on for
example battery capacity, slopes and grass
growth. When the product has operated the
allowed active period in a day, the message
1285 - 004 - 16.04.2020
Today's mowing complete is shown in the
display. The product is then in standby mode until
next day.
Model
Automower
Auto mode
4.6.1 Example 1
This example is applicable to products with a
specified work area of 500 m
the same for the other models.
Timer setting, Period 1: 07:00 - 23:00
Active period (A): 07:00 - 21:00
The timer setting ensures that the product begins
cutting the lawn at 07:00. However the product is
parked in standby mode in the charging station
from 21:00 and rests until it starts cutting again at
07:00.
0 .
Example: A specified work area of 500 m
Operation, A = max. hours
Charging/Standby, B = min. hours
4.6.2 Example 2
This example is applicable to products with a
specified work area of 500 m
the same for the other models.
The timer settings can be divided into 2 work
periods to prevent mowing when there usually is
other activities ongoing. If the timer setting is
divided into 2 work periods, the minimum standby
period must in total be according to the Standby
time table. Refer to
29 .
Standby time, minimum
hours per day
®
105 10
2
, but the principle is
2
, but the principle is
Timer and Standby on page
Operation - 29
2
14
10