Figure 5.1 Tda10021 Main User Interface Window; Table 5.1 Descriptions For The Tda10021 Main User Interface Window - Philips CU1216 Series Manual

FIGURE 5.1 : TDA10021 MAIN USER INTERFACE WINDOW
Channel
Settings

Table 5.1 Descriptions for the TDA10021 main user interface window

Channel Configuration
RF in [MHz]
SR [Mbaud]
Modulation
Spectral inversion
Program Fron-End
Channel Status
BER
RF AGC / IF AGC
MSE
AFC=xxKHz
Demodulator Setup Window
Tuner Setup Window
IIC Control Window
Activate Register Mode
Activate scanning mode
Scattering Diagram
BER graph
LEDs indicators
Program tuner and TDA10021
Set the RF input signal frequency in MHz
Set the symbol rate for the channel decoder in Msps
Set the QAM format (4, 16, 32, 64, 128 or 256QAM)
Automatic search for spectral inversion or force the spectal inversion
Run the algorithms to lock the complete system
BER indication after the demodulation (RS decoder input)
Value between 0 and 255 indicating the tuner AGC level. 0 = to much power/ 255
= not enough power
Mean square error indicating the signal quality (low MSE means good signal quality)
Indication of the corrected frequency drift in KHz
13
- -
BU RF Solutions
BER value
Tuner AGC and IF AGC indicator