Table of Contents
Advertisement
Verifying Parameters
Machine parameters are essential to any operation.
If the parameters are wrong, the machine will not
produce accurate results, and damage to the
machine and workpiece may occur.
The machine parameters were initially set at the
factory, but they can be changed or lost due to
hardware, software, or power issues. Consult this
section and Controller Functions on Page 6 to
verify and reset parameters.
Verify machine parameters before running
any operation whenever machine is pow-
ered ON. Parameters can be changed or
lost when power cycling occurs, and operat-
ing with incorrect parameters may result in
damage to machine or workpiece.
To verify machine parameters:
1.
Press MENU on controller, then scroll to
Machine Setup using the X+ and X- buttons,
and press OK.
2.
Scroll to each parameter shown on this page
and press OK to verify.
— To change a parameter, press RUN/
PAUSE, enter the new parameter, then
press OK to save.
-28-
Pulse Equivalent:
X Equival ................................................ 200.000
Y Equival ................................................ 200.000
Z Equival ................................................. 200.000
Table Size:
X Equival .............................................. 1300.000
Y Equival .............................................. 2500.000
Z Equival ................................................. 250.000
Home Setup:
Home Speed
X Equival .............................................. 6000.000
Y Equival .............................................. 6000.000
Z Equival ............................................... 6000.000
Set Home Direction
X Equival .......................................................Neg
Y Equival .......................................................Neg
Z Equival ........................................................ Pos
Max Speed Limit:
X Speed Limit
-Dir ........................................................ 4000.00
+Dir ........................................................ 4000.00
Y Speed Limit
-Dir ........................................................ 4000.00
+Dir ........................................................ 4000.00
Z Speed Limit
-Dir ........................................................ 3000.00
+Dir ........................................................ 1800.00
Model G0895 (Mfd. Since 01/20)
Advertisement
Table of Contents
