Advertisement
Fold
TROUBLE SHOOTING
PROBLEM
POSSIBLE CAUSE
A. Light switch is turned off.
Light will not come on.
B. Fuse is blown or circuit breaker is
turned off.
C. Incorrect circuit wiring.
D. There is too bright light from other
lamps to the sensor head.
E. The lamp is in a brighter
environment.
Lights come on during
A. The lamp may be installed in a
the day.
relatively dark location.
B. The ON-TIME setting option is set to
TEST mode where has no light control
function.
Lights come on for no
A. Lamp infrared motion sensor may be
apparent reason.
sensing moving objects such as trees,
traffic, etc.
B. Lamp infrared sensitivity be set too
high.
LINK cannot be
A. Lamp too far from lamp or blocked by
synchronized after
wall.
successful connection.
The distance between two lights is too far
or there is obstacle between two lights
LINK cannot be connected
A. Failed to connect as required by LINK
successfully.
operation.
11"
FCC WARNING:
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.
**********************************************************************************************
NOTES:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Fold
Fold
SOLUTION
A. Turn light switch on.
B. Replace fuse or turn circuit breaker
on.
C. Verify that fixture is wired properly.
D. Install the lamp farther away from
other one relative brightly.
E. Install the lamp in a dark
environment.
A. Reposition the lamp.
B. Switch the ON-TIME setting option
to another time location.
A. Reposition the lamp.
B. Reduce sensitivity of the motion
sensor.
A. Re-install the lights and keep the
distance between two light within 98 feet
and make sure there is no obstacle
between two lights.
A. Reconnect according to the LINK
operation.
Sky Rich Star Limited
UNIT E, 10/F, WORLDWIDE CENTRE,
123 TUNG CHAU STREET, TAI KOK TSUI,
KL, HONG KONG
Toll-free: 1-877-723-0723
Made in China
© 2019 Sky Rich Star Limited, all rights reserved.
The Honeywell Trademark is used under license
from Honeywell International Inc.
Honeywell International Inc. makes no
representations or warranties with respect
to this product. This product is manufactured for
Sky Rich Star Limited.
Fold
17"
Fold
Fold
LED Outdoor Security Flood Light
EN
Use and Care Guide
Read and Save this Instructions Before Use
Model: NW0130U20XXX
Advertisement
