Honeywell NK0145A30610 Use And Care Manual

Fold
TROUBLE SHOOTING
PROBLEM POSSIBLE CAUSE
A. Light switch is turned off.
Light will not come on. B. Fuse is blown or circuit breaker is
turned off.
C. Incorrect circuit wiring.
D. Motion sensor head is not aimed
correctly.
E. The light is in a brighter
environment.
Lights come on during A. Motion sensor may be installed
the day. in a relatively dark location.
B. Motion sensor is in TEST mode.
Lights come on for no A. Motion sensor may be sensing moving
apparent reason. objects such as trees, traffic, etc.
B. Sensitivity may be set too high.
A. Heat or light from the lamp heads may
Lights flash on and off.
be turning the motion sensor on and off.
B. Heat being reflected from other objects
may be turning the motion sensor on and
off.
FCC WARNING:
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.
11"
**********************************************************************************************
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
NOTES:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
RF EXPOSURE:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with minimum distance of 20
cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
EN | 4
Fold
Fold
SOLUTION
A. Turn light switch on.
B. Replace fuse or turn circuit breaker
on.
C. Verify that fixture is wired properly.
D. Re-aim the motion sensor to cover
the desired area.
E. Install the lamp in a dark
environment.
A. Reposition motion sensor.
B. Switch the ON-TIME setting option
to another time location.
A. Reposition motion sensor.
B. Reduce sensitivity.
A. Reposition lamp heads away from
the motion sensor.
B. Reposition motion sensor.
Sky Rich Star Limited
UNIT E, 10/F, WORLDWIDE CENTRE,
123 TUNG CHAU STREET, TAI KOK TSUI,
KL, HONG KONG
Toll-free: 1-877-723-0723
Made in China
© 2019 Sky Rich Star Limited, all rights reserved.
The Honeywell Trademark is used under license
from Honeywell International Inc.
Honeywell International Inc. makes no
representations or warranties with respect
to this product. This product is manufactured for
Sky Rich Star Limited.
Fold
17"
Fold
Fold
LED Triple Head Linkable Security Light
EN
With 270° Motion Detection
Use and Care Guide
Read and Save These Instructions Before Use
Model: NK0145A30610