Cisco Catalyst IW6300 Heavy Duty Series Installing Manual page 25

Installing the Access Point
Warning
To reduce risk of electric shock, connect the unit only to DC power source that complies with the Safety
Extra-Low Voltage (SELV) requirements in IEC 60950 based safety standards or ES1 requirements in IEC
62368 based safety standards. Statement 1033
To route and connect the power cable to the IW-6300H-DCW-x–K9 model, follow these steps:
Procedure
Step 1 Open the access point cover. See
Step 2
Ensure a 6 AWG ground wire is connected to the access point (see
Step 3 Route the power cable through the 1/2 NPT port.
Step 4
Use a wire stripper tool to remove the insulation from each wire. Remove only enough wire to provide a solid
connection in the terminal block. The hot wires should have no bare wire exposed after the connection is
made.
Step 5
Insert the ground wire into the internal ground.
Step 6 Insert each hot wire into the terminal block.
Figure 17: IW-6300H-DCW-x-K9 Internal Ground and Terminal Block Location
1
Step 7 Use a Phillips screwdriver to tighten the terminal block set screws to secure the wires in the terminal block.
Step 8
Verify that no bare wire is exposed. If wire is exposed, remove it from the terminal block, adjust the length,
and reinstall.
Step 9
Check your work.
Step 10 Close the access point cover. See
Opening the Access Cover, on page 13
Terminal block
Closing the Access Cover, on page 14
Connecting DC Power to IW-6300H-DCW-x-K9
for instructions.
Grounding the Access Point , on page
2 Internal ground
for details.
Installing the Access Point
19).
25