Advertisement
IH25 (900 MHz) Compliance Insert
For Users in English-Speaking Regions
Caution: This marking indicates that the user should read all included documentation before use.
Users of this product are cautioned to use accessories and peripherals approved by Honeywell. The use of accessories other than those
recommended, or changes to this product that are not approved by Honeywell, may void the compliance of this product and may result in the
loss of the user's authority to operate the equipment.
Battery, Charger, and Power Supply Information
Caution: For use with Honeywell battery pack Model BAT-EDA50 only. No user-serviceable parts.
Charge only in or with Honeywell recommended models adapter or charger. Use of incorrect charger may present a risk of fire or
explosion. Promptly dispose of used battery pack according to the instruction.
Caution: The battery pack used with this product may ignite, create a chemical burn hazard, explode, or release toxic materials if
mistreated. Do not incinerate, disassemble, or heat above 100 °C (212 °F). Do not short circuit; may cause burns. Keep away from
children.
Battery Recycling Information
This product contains or uses a lithium-ion (Li-ion) main battery. When the battery reaches the end of its useful life, the spent
battery should be disposed of by a qualified recycler or hazardous materials handler. Do not mix this battery with the solid
waste stream. Contact your Honeywell Technologies Service Center for recycling or disposal information.
Li-ion
Li-ion
Radiation Exposure Statement
Radio Wave Exposure and Specific Absorption Rate (SAR) Information
Warning: This equipment complies with International Commission on Non-Ionizing Radiation Protection (ICNIRP), IEEE C95.1,
Federal Communications Commission Office of Engineering and Technology (OET) Bulletin 65, Canada RSS-102, and European
Committee for Electrotechnical Standardization (CENELEC) limits for exposure to radio frequency (RF) radiation.
Use of antennas and accessories not authorized may void the compliance of this product and may result in RF exposures beyond the limits
established for this equipment.
U.S.A. and Canada
U.S.A. Digital Emissions Compliance
This device complies with part 15 of the FCC Rules and with Industry Canada license-exempt RSS standards. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that can cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the radio or television receiving antenna.
•
Increase the separation between the computer equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the radio or television receiver is connected.
•
Consult the dealer or an experienced radio television technician for help.
Canadian Compliance
This device complies with Industry Canada license-exempt RSS standards. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
CAN ICES-3 (B)/NMB-3(B)
1
Advertisement
