Makita DWD181 Instruction Manual page 43

Operation
7. Align the guide laser (the sensor's
right and left edge lines) with the
middle masking tape line, and slowly
move the scanner on the line.
NOTE
• Start scanning on the vertical
masking tape line so that the starting
position of scan can be aligned with
that of the upper line.
8. Scan results are shown on the
display. The scan results of the
"middle line" are shown in line 2 if the
scanner is released from the
concrete surface.
9. Align the guide laser (the sensor's
right and left edge lines) with the
lower masking tape line, and slowly
move the scanner on the line.
NOTE
• Start scanning on the vertical
masking tape line so that the starting
position of scan can be aligned with
that of the upper line.
43