Advertisement
STEP 6
Using a 10mm socket, remove the
(1) bolt on each side of the grille on
the bottom. Once removed, you can
remove the entire grille.
See Figure 6
STEP 7
Separate the active shutters from the
grille by removing the 10mm bolts.
Then slide on the provided hardware
as shown. Note the two short u-nuts
go on the outer edges. Be careful and
remove the wire harness from active
shutters.
See Figure 7, 7.1
STEP 8
Install the brackets (left and right)
using the provided hardware. Then
install the RIGID lights.
See Figure 8
FIGURE 6
FIGURE 7
FIGURE 7.1
FIGURE 8
Advertisement
