Summary of Contents for RIDGID 2017 FORD RAPTOR GRILLE MOUNT
Page 1
INSTALLATION INSTRUCTIONS 2017 FORD RAPTOR ® ® GRILLE MOUNT PRODUCT INCLUDES: (1) Raptor Grille Mount * LIGHTS SOLD SEPARATELY *THIS MOUNT FITS THE FOLLOWING LIGHTS: (2) 6” SR-Series ® IMPORTANT THANK YOU FOR PURCHASING RIGID INDUSTRIES’ PRODUCTS FOR YOUR VEHICLE. Please read through all of these Instructions and tips before proceeding with the installation.
Page 2
STEP 1 FIGURE 1 Open hood and remove the plastic push pins that attach the plastic radiator shield. Use push pin pliers, non-marring prybar or equivalent. See Figures 1 & 1.1 FIGURE 1.1 STEP 2 FIGURE 2 Unplug the 3 harness ends and move them out of the way as shown.
Page 3
STEP 4 FIGURE 4 Remove the (4) 10mm bolts on the top of the grille and set them aside. See Figure 4 FIGURE 5 STEP 5 Pull headlight trim by pulling straight out from the front of the vehicle using gentle force. Make sure not to lose any retaining clips when pulling.
Page 4
FIGURE 6 STEP 6 Using a 10mm socket, remove the (1) bolt on each side of the grille on the bottom. Once removed, you can remove the entire grille. See Figure 6 FIGURE 7 STEP 7 Separate the active shutters from the grille by removing the 10mm bolts.
STEP 9 Once the lights are mounted, install the active shutters back on to the grille and reinstall the factory bolts/nuts. Installation is the reverse of removal. Wiring: Wire your lights according to the instructions included with the light. Take care to avoid any heat sources and sharp or abrasive surfaces. Your installation is now complete.