Page 1
2 MP Series Turret Camera User Manual User Manual Thank you for purchasing our product. If there are any questions, or requests, do not hesitate to contact the dealer. This manual applies to the models below: Model DS-2CE70D0T-ITMF This manual may contain several technical incorrect places or printing errors, and the content is subject to change without notice.
Regulatory Information FCC Information Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC compliance: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
Page 3
Safety Instruction These instructions are intended to ensure that user can use the product correctly to avoid danger or property loss. The precaution measure is divided into “Warnings” and “Cautions”. Warnings: Serious injury or death may occur if any of the warnings are neglected.
Mark Description Table 0-1 Mark Description Mark Description DC Voltage 1 Introduction Main Features High performance CMOS sensor Low illumination, 0.01 Lux @ (F1.2, AGC ON), 0 Lux with IR IR cut filter OSD menu with configurable parameters ...
2 Installation Before you start: Make sure that the device in the package is in good condition and all the assembly parts are included. Make sure that all the related equipment is power-off during the installation. Check the specification of the products for the ...
Page 6
Figure 2-3 Install the Mounting Base to Wooden Ceiling 2). Drill holes for installing expansion bolts at first, then install the mounting base to cement ceiling with two PA4 × 25 screws. Figure 2-4 Install the Mounting Base to Cement Ceiling Note: The supplied screw package contains self-tapping screws, and expansion bolts.
3 Menu Description Please follow the steps below to call the menu. NOTE: The menu description part is for your reference only. It might have some differences due to the specific model that you have. Steps: 1. Connect the camera with the TVI DVR, and the monitor, shown as the figure 3-1.
3) Click left/right direction button to adjust the value of the selected item. 3.1 VIDEO FORMAT You can select the video format as 2MP @ 25fps or 2MP @ 30fps. 3.2 EXPOSURE EXPOSURE MODE You can set the EXPOSURE MODE as GLOBAL, BLC, HLC, or DWDR.
Figure 3-3 DAY/NIGHT IR LIGHT You can turn on/off the infrared to meet the requirements of different circumstances. SMART IR The Smart IR function is used to adjust the light to its most suitable intensity, and prevent the image from over exposure.
CONTRAST This feature enhances the difference in color and light between parts of an image. You can set the CONTRAST value from 1 to 9. SHARPNESS Sharpness determines the amount of detail an imaging system can reproduce. You can set the SHARPNESS value from 1 to 9.