Troubleshooting - Panasonic ECONAVI NA-FS20V5SRY Operating & Installation Instructions Manual

Troubleshooting

Before requesting service, make the following checks. If the problem persists, consult the
service center for instructions.
Problem
The washing
machine fails to
start.
Keys pressed and
failed to response.
Abnormal noise
and vibration.
No water supplied.
Water pressure too
low.
Water level too
high in terms of
load.
Water level too low
in terms of load.
No water feeding
when rinse cycle is
started.
The washing
machine starts
rinsing during
Spining cycle.
● Is there power outage?
● Is "On / Off" key pressed?
● Is power plug connected correctly?
● Is fuse broken or main switch disconnected?
● The "Water level" key is available only in water feeding
and washing cycle.
The "Wash", "Rinse", and "Spin" key is available only
after pressing the "Start / Pause" key before water
feeding and washing cycle is ended. You may have
to power off and on the washing machine once after
settings are changed.
● Do not place the washing machine on floor uneven or
unstable.
● Is it imbalanced with clothes?
→ Press "Start / Pause" key, balance load, resume the
suspended cycle.
● Is faucet opened?
● Is running water cut or its pressure too low?
● Is water feeding valve filter jammed by dirt?
→ Clean the water feeding valve filter.
● Water level may get too high by placing soaked cloths
in tub or the tub if left with water before cycle getting
started.
→ Press "Water level" key to change water level.
● Light clothes of synthetic or blended fibers may get
water level lower.
→ Press "Water level" key to change water level.
● The washing machine starts feeding water after drying
cycle in case the tub contains no water.
● It drains first if there is water left in tub.
● The washing machine may auto balance load with
rinsing.
→ Place load in balance.
Check points Page
–
–
–
–
7
24
–
-
-
22
7
7
–
–
–
25