Zanussi ZWF71463W User Manual page 15

After approximately 15 minutes from
the start of the programme:
• The appliance adjusts automatically
the programme duration agree with
the laundry load.
• The display shows the new value.
STARTING A PROGRAMME WITH THE
FINISH IN OPTION
1. Touch the button
the number of hours in which you want the
washing cycle to be finished.
The display shows the number of hours you set
(e.g. ) and the indicator above the button
on to show that his option is active.
2. Touch the button
• The door is locked.
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the Finish In option before you touch
the button
button you can only cancel the
Finish In option.
To cancel the the Finish In option:
a. Touch the button
to pause. The indicator of button
flashes.
b. Touch the button
above this button goes off.
Touch the button
programme immediately.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
1. Touch .
The indicator of this button flashes.
2. Change the options. If you change any option
the Finish In option (if set) will be disabled.
3. Touch again.
The programme continues.
again and again to choose
:
. After touching the
to set the appliance
until the indicator
again to start the
CANCELLING A PROGRAMME
1. Press the button On/Off for some seconds to
cancel the programme and to deactivate the
appliance.
2. Press the same button again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. In
this case, make sure that the detergent
is still in the detergent compartment, if
not fill the detergent again.
OPENING THE DOOR
is
While a programme (or the
appliance door is locked. The indicator
CAUTION! If the temperature and
level of the water in the drum are too
high, you cannot open the door.
To open the door during the first minutes of
the cycle (or when the
1. Touch the button
2. Wait until the indicator
3. You can open the door.
4. Close the door and touch the button
The programme (or the
AT THE END OF THE PROGRAMME
• The appliance stops automatically.
• The acoustic signal operates (if it is activated).
• In the display
• The indicator of the button
• The door lock indicator
• You can open the door.
• Remove the laundry from the appliance. Make
sure that the drum is empty.
• Press the button
deactivate the appliance.
• Close the water tap.
• Keep the door and the detergent drawer ajar, to
prevent the mildew and odours.
The washing programme is completed, but
there is water in the drum:
• The drum turns regularly to prevent the creases
in the laundry.
• The indicator
the water.
) operates, the
operates) :
to pause the appliance.
goes off.
) continues.
comes on.
goes off.
goes off.
for some seconds to
flashes to remind you to drain
is on.
again.
15