Troubleshooting - Husqvarna AX 36 Operator's Manual

2. Examine the diaphragm (A), replace it if it is
damaged or worn.
Problem Cause
The product The power source is not star-
does not start. ted.
There is no power in the outlet.
The wires in the hose are dam-
aged.
The wires in the vibrator head
are damaged.
The ON/OFF switch is broken.
The power The load is too high for the
source stops power source.
when the prod-
uct is started.
The vibrator head motor is de-
fective.
1006 - 002 - 27.03.2020
A

Troubleshooting

3. Use compressed air to blow a cord into the hose
from the switch box side.
4. Attach the cord to the wire harness and pull the
harness into the hose.
Inspection
N/A
Examine the voltage of each
phase in the outlet.
Examine the resistance of the
product.
Examine the resistance in the
vibrator head.
Examine the resistance of the
product when you put the
ON/OFF switch to "ON" and
"OFF".
Examine the information on the
rating plate on the product.
Make sure that the power
source is of the correct type.
Examine the ground insulation
of the vibrator head.
Solution
Start the power source.
Replace or repair the outlet.
Replace the damaged wires.
Let an approved Husqvarna
service center do a repair of the
vibrator head.
Replace the ON/OFF switch.
Make sure that there is suffi-
cient power to the power
source and to the product.
Replace the stator tube if it is
necessary.
11