Replacing The Power Supply Unit - Fujitsu PRIMERGY CX122 S1 Service Supplement Manual

Replacing the power supply unit

4.8 Replacing the power supply unit
Ê Open the server as described in
Ê Remove all components except the power supply unit from the chassis as
shown in the related sections:
– Heat sinks:
– Processors:
– Memory modules:
– Expansion cards:
– PCI riser card:
– System board:
84
section "Removing a heat sink" on page 58
section "Removing a processor" on page 60
section "Removing a memory module" on page 73
section "Replacing expansion cards" on page 48
section "Replacing the PCI riser card" on page 53
section "Replacing the system board" on page 77
Service Supplement
A pre-assembled replacement
chassis / PSU kit is available
under the following part
number:
S26361-K1378-V900
I
section "Opening the server" on page
The CX122 S1 PSU
(460 W, open frame) is
not available as a
separate spare part.
PRIMERGY CX122 S1
31.