Honeywell e7w Installation Instructions Manual page 8

e7w WIRELESS EMS THERMOSTAT - INSTALLATION INSTRUCTIONS
BINDING AUXILIARY DEVICES
Note:
Before binding or verifying auxiliary devices.
• e7w must be configured with correct Room
ID, PAN ID, and RF Channel.
•
For forward bind method, place the remote
device into a discovery mode that can re-
ceives the request sent from the thermo-
stat and reply to the request.
• For reverse bind method, mount the ther-
mostat in a such location, that can receive
request sent from the remote device and
reply to the request.
Binding PC502.4G
1. Enter SERVICE MODE. use the UP/DOWN
arrow buttons to select Io.
2. Press MODE. The information display
changes to show Io and a value.
3. Use the UP/DOWN arrow buttons to change
the displayed value range from 0 to 255. Set
the Io value to the desired I/O map number.
4. Press FAN to initiate a reverse bind.
5. Press Reset/Bind switch on the PC502.4g
(use a small point like the end of a straight-
ened paper clip).
If the PC502.4G binds successfully, it will
flash Led and send message to make the unit
beep, confirming that the bind was success-
ful.
6. Press FC to exit service mode.
Binding Door/Window/Balcony
Switch
1. Enter SERVICE MODE, use the UP/DOWN
arrow buttons to select Io.
2. Press MODE. The information display
changes to show Io and a value.
31-00308-01
3. Use the UP/DOWN arrow buttons to change
the displayed value range from 0 to 255. Set
the Io value to the desired I/O map number.
4. Press FAN to initiate a reverse bind or press
MODE to initiate a forward bind.
5. Press the S1 switch on the device to initiate
binding process.
If the device binds successfully, it will flash
Led and send message to make the unit
beep, confirming that the bind was success-
ful.
6. Press FC to exit service mode.
Figure 11: Configuring IO mode
VERIFYING AUXILIARY DEVICES
1. Enter SERVICE MODE, use the UP/DOWN
arrow buttons to select PnG.
2. Press MODE. The information display
changes to show PNG and a value.
3. Use the UP/DOWN arrow buttons to the ad-
dress of the target device to be pinged.
4. Press FAN to initiate pinging the target de-
vice. After few seconds, it will start communi-
cating the reply and values will be displayed.
5. Press the FC button to stop pinging.
6. Press FC to exit service mode.
8