Table of Contents
Advertisement
xp CDR820/00 eng.-1
30-08-2001 11:18
Installation
Digital optical connections via a digital receiver
If you have a receiver with digital optical in- and outputs, these
connections allow you to make digital recordings from various
sources, connected to the receiver.
2
1
Remove the dust caps from the digital optical connections of
both source and CD recorder. Keep the caps in a safe place.
2
Connect an optical fibre-optic cable
between the OPTICAL IN- and OUT
sockets of the set and optical in- and
output sockets on the digital receiver.
Make sure you insert both plugs
fully, until a click is heard.
Any digital device, connected to the digital input sockets of
the digital receiver (e.g. CD and DVD) can now be used as
recording source.
Digital coaxial connections via a digital receiver
If you have a receiver with digital coaxial in- and outputs, these
connections allow you to make digital recordings from various
sources, connected to the receiver.
1
1
Connect a digital coaxial cable between the DIGITAL IN- and
OUT sockets on the set and e.g. the (digital) AUX in- and
output sockets on the digital receiver.
Any digital device, connected to the digital input sockets of
the digital receiver (e.g. CD and DVD) can now be used as
recording source.
12
Pagina 12
DIGITAL
RECEIVER
2
CD RECORDER
DIGITAL
RECEIVER
1
CD RECORDER
Power supply/Mains
3
The type plate is located on the rear of the set.
1
Check whether the mains voltage as shown on the type plate
corresponds to your local mains voltage. If it does not, consult
your dealer or service organisation.
2
Make sure all connections have been made before switching on
the mains supply.
3
Connect the mains lead supplied to AC MAINS ~ and to the
wall socket.This switches on the mains supply.
4
Press POWER to switch on the set.
Press POWER again to switch off the set.
0
When the set is switched off, it is still consuming some power.
To disconnect the set from the mains completely, remove the
mains plug from the wall socket.
Demo mode
The demo mode displays various features of the set and will
start automatically when no key has been pressed for several
minutes or during Standby mode.
To cancel demo mode
Keep STOP 9 on the set pressed for at least 5 seconds.
0
The demo mode is cancelled permanently.
will be displayed.
Advertisement
Table of Contents
