Power Supply/Mains; Demo Mode - Philips CDR800 - annexe 2 Manual

xp CDR800/17 eng./dr.5 09-02-2001 12:11
Digital coaxial connections via a digital receiver
1
If you have a receiver with digital coaxial in- and outputs, these
connections allow you to make digital recordings from various
sources, connected to the receiver.
1 Connect a digital coaxial cable between the DIGITAL IN-
and OUT sockets on the set and e.g. the (digital) AUX in-
and output sockets on the digital receiver.
Any digital device, connected to the digital input sockets
of the digital receiver (e.g. CD and DVD) can now be
used as recording source.

Power supply/Mains

3
The type plate is located on the rear of the set.
1 Check whether the mains voltage as shown on the type
plate corresponds to your local mains voltage. If it does not,
consult your dealer or service organisation.
2 Make sure all connections have been made before
switching on the mains supply.
3 Connect the mains cable supplied to AC MAINS ~ and to
the wall socket.This switches on the mains supply.
4 Press POWER to switch on the set.
WELCOME TO PHILIPS AUDIO will be displayed.
Press POWER again to switch off the set.
0
When the set is switched off, it is still consuming some
power.To disconnect the set from the mains completely,
remove the mains plug from the wall socket.
Pagina 13
DIGITAL
RECEIVER
1
CD RECORDER

Demo mode

The demo mode displays various features of the set and
will start automatically when no key has been pressed for
several minutes or during Standby mode.
To cancel demo mode
Keep STOP 9 on the set pressed for at least 5 seconds.
0
The demo mode is cancelled permanently.
Installation
13