Prior To Operation; How To Use - Hitachi WH 14DCL Handling Instructions Manual

PRIOR TO OPERATION

Setting up and checking the work environment
○
Check if the work environment is suitable by the above precautions.

HOW TO USE

1. Installing the bit
Always follow the following procedure to install driver bit.
(Fig. 6)
(1) Pull the guide sleeve forward.
(2) Insert the bit into the hexagonal hole in the socket.
(3) Release the guide sleeve and it returns to its original
position.
CAUTION
If the guide sleeve does not return to its original
position, then the bit is not installed properly.
2. Removing the bit
Please do the opposite point on the method of
installing bit.
3. Confi rm that the battery is mounted correctly
4. Check the rotational direction
The bit rotates clockwise (viewed from the rear side)
by pushing the R-side of the selector button.
The L-side of the selector button is pushed to turn the bit counterclockwise (See Fig. 7)
(The and
5. Switch operation
CAUTION
Before using, confi rm that the switch lever returns to its original position
○
when pulled and then released. Failure of the switch lever to operate properly
can result in injury.
Do not hang the angle impact driver from a belt and the like by the switch
○
lever. The angle impact driver may drop causing an accident. In addition, this
can also damage the switch lever.
When carrying the angle impact driver, confi rm that the lock button is in the
○
OFF position. Carrying the angle impact driver with the lock switch in the ON
position can cause the switch to inadvertently be turned on resulting in injury.
Do not carry the angle impact driver by the switch lever when carrying. This
○
can cause a malfunction.
Be careful not to pinch your fi nger between the switch lever and the angle
○
impact driver. This can cause an injury.
marks are provided on the body).
Driver bit
Switch
lever
25
English
Movement
Hexagonal
hole in the
Guide sleeve
anvil
Fig. 6
Selector
button
mark
Fig. 7
mark