Makita DML811 Instruction Manual page 5

Insert the battery cartridge. Align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place with
a little click. If you can see the red indicator on the upper
side of the button, it is not locked completely. Then close
the battery cover.
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
CAUTION:
• Always install the battery cartridge fully in place. If not,
it may accidentally fall out of the appliance, causing
injury to you or someone around you.
• Do not install the battery cartridge forcibly. If the
cartridge does not slide in easily, it is not being
inserted correctly.
Indicating the remaining battery capacity
(Only for battery cartridges with the indicator)
1
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for few seconds.
Indicator lamps
Lighted Off
1. Indicator lamps
2. Check button
2
Remaining capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the battery.
The battery may
have malfunctioned.
NOTE:
• Depending on the conditions of use and the ambient
temperature, the indication may differ slightly from the
actual capacity.
Use of non-genuine Makita batteries, or batteries that
have been altered, will void the Makita warranty for the
Makita appliance and charger.
Use with AC power:
When using the appliance with AC power, use the power
cord which is supplied with the appliance. Let the female
plug insert to the appliance and connect the male plug to
an outlet.
CAUTION:
• Insert the female plug into the appliance first
completely, then connect the male plug to an outlet.
• Always close the socket cover firmly when the power
cord is not plugged.
NOTE: The AC power does not charge the battery
inserted to the appliance.
NOTE: Even operating in DC power, the appliance
automatically changes to AC power when the power cord
is plugged in.
Organizing the power cord:
1. Power cord
2. Fastener
Coil power cord on stand tightly, then clip end of the cord
by using fastener attached.
Turning on the light and brightness mode selection
1. Switch : Press the switch once, the light turns on (At
the same brightness mode as the last setting). Press the
switch again, the light turns off.
1. Power cord
2. Socket cover
3. Female plug (for
the appliance)
4. Male plug (for
AC source, the
shape varies
from country to
country)
1. Switch
2. Brightness
mode selection
5