Advertisement
Recycling the PCB Assembly (PCBA)
Step 3
Remove the cover plate.
a) Open the fan compartment doors by pushing the latches inward toward each other.
b) Using a screwdriver, rotate each of the Midplane assembly screws counter-clockwise until it disengages.
c) Grasp the cover and remove it by hand.
The following illustration shows the location of the screws.
Figure 3: Location of Mounting Screws for Midplane Cover (Top Down View)
Step 4
Remove the Midplane PCBA.
a) Remove all the fans (if present).
b) Remove the fan cage.
c) Disconnect the sensor connector from the motherboard.
d) Locate the cable tie on the interior chassis wall and cut the tie so that the cables are no longer attached to the chassis.
e) Lift the Midplane assembly straight up to disconnect it from its sockets and remove it from the chassis.
The following image shows the locations of these components.
Cisco UCS S3260 Storage Server PCBA Disassembly For Commission Regulation (EU) 2019/424 Service Note
Recycling the PCB Assembly (PCBA)
7
Advertisement
