Cisco PowerVu D9850 Quick Setup Instructions

Before you start, review the following information and enter your Receiver User Address:
Program to receive:
Program Provider:
Satellite & Transponder:
Polarization:
Downlink Frequency
Symbol rate:
Network ID:
FEC Rate:
Receiver User Address (UA): (found
on the rear panel)
Step-by-Step Instructions
1. Connect the L-Band signal to the RF IN connector.
Note that LNB power is only available via the RF input #1 for multiple RF models. The
factory default setting for RF 1 LNB power is OFF. (If you need the receiver to power
your LNB, details are provided in the User Manual shipped with the receiver.
2. Connect video and audio outputs to monitors.
3. Connect the AC power source. Wait for the receiver to fully boot up. Once ready, the
default status menu will appear [CH:XXX Name:XXXX] For an initial installation, the
channel number will be 0 and the channel name will be "Not Available".
4. Press Menu to move from the initial display into the Main Menu system.
5. Press the right arrow key so the cursor is to the left of the Preset/Input menu item.
Press the Select button to display the
QUICK SETUP INSTRUCTIONS
TV JAPAN
PowerVu D9850 Program Receiver
TV JAPAN
NHK Cosmomedia America, Inc.
Galaxy 13 4C
Vertical
L-band 1350 (03.800 GHz)
27.69 Msym/s
8002
3/4
Preset/Input
menu.