Cisco 2500 Series Installation And Configuration Manual page 44

Configuring the Router
memory.
Processor board ID 2685538369
SuperLAT software copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software (copyright 1994 by TGV Inc).
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
Bridging software.
Authorized for Enterprise software set. (0x0)
1 Ethernet/IEEE 802.3 interface.
2 Serial network interfaces.
8 low-speed (sync/async) network interfaces.
32K bytes of non-volatile configuration memory.
4096K bytes of processor board System flash (Read ONLY)
Notice: NVRAM invalid, possibly due to write erase.
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Step 3 Enter yes or press Return (the default) when you are asked if you would like to enter the configuration
dialog and if you would like to see the current interface summary:
Would you like to enter the initial configuration dialog? [yes]:
First, would you like to see the current interface summary? [yes]:
Any interface listed with OK? value "NO" does not have a valid
configuration
Interface IP-Address OK? Method Status
Ethernet0
Serial0
Serial1
Serial2
Serial3
Step 4 Choose the supported protocols on the Ethernet or Token Ring interface. For IP-only installations,
accept the default values for most of the questions.
A typical configuration using IP, IPX, and AppleTalk follows:
Configuring global parameters:
Enter host name [Router]: router
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/cis2500/2520/2520_23/c2520cfg.htm (6 of 16) [10/27/2000 3:07:51 PM]
unassigned
unassigned
unassigned
unassigned
unassigned
Protocol
NO not set
NO not set
NO not set
NO not set
NO not set
up down
down down
down down
down down
down down