Rack-Mounting The Chassis - Cisco 2500 Series Installation And Configuration Manual

Installing the Router
Figure 3-1: Identifying the Rubber Feet
Step 2 Place the chassis upside down on a smooth, flat surface.
Step 3 Peel off the rubber feet from the black adhesive strip and place them adhesive-side down onto the
five round, recessed areas on the bottom of the chassis, as shown in
Figure 3-2: Installing the Rubber Feet
Step 4 Place the router right-side up on a flat, smooth, secure surface.
Caution Do not place anything on top of the router that weighs more than 10 pounds (4.5 kg).
Excessive weight on top could damage the chassis.

Rack-Mounting the Chassis

This section describes the procedures for rack-mounting the chassis. The chassis comes with brackets for
use with a 19-inch rack or, if specified in your order, optional larger brackets for use with a 24-inch rack.
The brackets are shown in
Figure 3-3: Identifying the Brackets
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/cis2500/2520/2520_23/c2520ins.htm (3 of 14) [10/27/2000 3:07:47 PM]
Figure 3-3.
Figure 3-2.